During playback the calibration scope should display a stable timecode signal as pictured below for timecode vinyl and timecode cd.
Traktor scratch vinyl low input.
My set up consist of a numark 4 trak and 2 pioneer plx 1000 turntables with control vinyl mk2 red.
Connecting a turntable to the traktor s4 mk3.
Yes and it still doesn t work on traktor pro 3.
Check phono line configuration or unknown medium calib.
Traktor receives a timecode signal from a timecode cd but the input mode for audio 8 4 dj is set to timecode vinyl.
Set the input mode on the audio 4 dj to line cd control.
Make sure that your inputs are set to phono on both the traktor interface and your dj mixer.
Failed with traktor scratch pro 2 turntables and audio 6.
I can control it with the time code vinyl etc but all the time there is this message showing either low input.
Set the input mode on audio 8 dj to timecode cd line.
Open dialog preferences audio setup and select an audio interface compatible with traktor scratch.
Low input and unknown medium.
This is for regular vinyl playback using traktor.
All the setup action needed for getting traktor scratch duo working with timecode is about getting the signal path between the turntable cdj and the master out of the mixer properly configured.
Low input unknown medium calib.
Ive been running traktor scratch pro 2 for years without problems on my macbook pro late 2011.
The following figure shows the signal path when using timecode vinyl.
The traktor kontrol s4 gives djs the option of integrating turntables and using them to play vinyl or control the decks with timecode vinyl.
I had the same problem when i first tried hooking up my fs2 system and it was because the dj mixer was set to line level input but fs2 was phono.
Audio setup output routing input routing are ok.
The mixer channels on the s4 allow you to connect up to two phono level audio devices.
Traktor scratch pro v2 2 10 6.
1x technics 1200 mk2.
A turntable that requires a separate phono preamp has to be connected to mixer channel a or b.
Time code setup is on scratch mode.
When i use the time code vinyl i get the same low frequency mentioned above mkii vinyl and new cartridges second on the xdj 1000 mk1 sound only comes out to my mixer on one channel on my external mixer.
Edit 2013 thanks for all your replies the problem was fixed a long time ago now as it turned out my laptop wasn t p.
For more information on relative and absolute mode as well as troubleshooting timecode calibration please refer to chapters tracking modes and traktor scratch pro 2 troubleshooting in the traktor 2 user manual.
