Using A Safety Harness On A Roof

The warning line system shall consist of ropes wires or chains and supporting stanchions 29 cfr 1926 502 f 2.

Using a safety harness on a roof.

The safety harness for roofing should feel snug on your body but not too tight so you could still move freely. Never reuse a harness or lanyard that has been. Inspect the harness and lanyard for loose stitching and worn webbing. The use of a personal safety harness is also required when working around floor openings and on any roof without handrails when the worker is less than 6 feet from the edge.

Put on the harness and adjust the shoulder straps. Or on roofs 50 feet 15 25 m or less in width the use of a safety monitoring system alone is permitted 29 cfr 1926 501 b 10. Inspect the roofing harness for any damage. Step 1 nailing on the roof brackets with a hammer nail a row of roof brackets about 3 feet apart and 16 inches up.

Adjust the harness buckles for a snug fit. Throw rope with at least 700kg breaking strain right over roof. The safety monitor is always a competent person 29 cfr 1926 500 b. Check with the safety department of your company for any more stringent policies prior to engaging in overhead work.

Locate the roof anchor directly above where you ll be working on the roof. So by following these few easy steps you can properly use a roof safety harness. When on a roof you need to wear a harness connected to a securely anchored safety rope. The brackets should be placed directly on top of a truss.

Companies can make osha s requirement more strict. Step 3 tie rope to a structural part of house or a tree. Wearing a full body safety harness is the next essential thing when it comes to rooftop safety.